Launch X-431 Anti-theft Key Matching Tool (X431 IMMO Plus/X431 IMMO Elite) with Chrysler Anti-theft diagnostic software can perform functions such as key matching, anti-theft module replacement, and password reading for Chrysler/Jeep/Dodge series, and ECUs cover wireless control module, radio frequency hub, body control module and more systems. Here takes 2016 Chrysler Ram 1500 Radio Frequency Hub- Tire as a demonstration.
Tips:
Please keep the network connection and login normally during the operation. Otherwise, the data may be inaccurate.
The procedures:
Connect Launch X431 IMMO key programmer and vehicle
Tap IMMO>> CHRYSLER V10.03>> Immobilizer>> Automatically Search
Check if there are any other OBD communication components are installed on the vehicle, remove it if yes and then perform diagnosis.
Identify the VIN and the vehicle is 2016 RAM 1500
Tap Immobilizer System Detection>> Immobilizer System Selection>> RFH/TPMS (Radio Frequency Hub- Tire)>> Special function
Perform the functions as below.
Step 1: Read Immobilizer Password (PIN Code)-intelligent Key/FOBIK
Step 2: Erase Ignition FOBIKs
Step 3: View Ignition (IGNM/KIN) Part Information
Step 4: Program Ignition FOBIKs
Step 5: View Ignition (IGNM/KIN) Part Information
Step 6: BCM (Body Control Module) Replaced
Step 7: Program Tire Sensor Identifications
Step 1: Read Immobilizer Password (PIN Code)-intelligent Key/FOBIK
Perform this function may change the state of the vehicle. Please exercise caution!
Switch ignition off and turn on emergency flasher.
Read the password is 3721.
Step 2: Erase Ignition FOBIKs
This function erases all ignition FOBIKs currently programmed to this vehicle. Place the start switch in the run state.
Enter the Vehicle PIN (personal identification number). The PIN can be found by authorized personnel on manufacturer’s website.
Verify the PIN
Step 3: View Ignition (IGNM/KIN) Part Information
The PIN unlock was successful. Continue to erase the ignition FOBIKs.
All ignition FOBIKs have been erased by Launch X-431 IMMO Plus/Elite for this vehicle. Change start switch to lock state.
Step 4: Program Ignition FOBIKs
The FOBIKs being programmed must be inside the vehicle near the center console during this procedure. Make sure that there are no wireless devices (Notebook, scan tool, cell phone) within close proximity of the FOBIKs being programmed.
Place the start switch in the ignition lock state.
Enter vehicle PIN and verify it is correct. (same as step 2)
Step 5: View Ignition (IGNM/KIN) Part Information
Have the FOBIK to be programmed readily available in your hands. Once you continue you will need to get into the vehicle and press the unlock button within 30 seconds. The key fobik should be in the vehicle near the center console when the unlock button is pressed and remain there until it is programmed.
Program ignition FOBIK successfully
Step 6: BCM (Body Control Module) Replaced
Use this function when the BCM has been replaced. It will backup the secret key value in the RF-HUB to the BCM.
Place the start switch in the run state.
Enter vehicle PIN and verify (same as step 2)
Step 7: Program Tire Sensor Identifications
Transferring Secret key from the RF-HUB to the BCM… This may take up to 60s, please wait…
Transfer was successful.
Done! It’s very easy and fast to do anti-theft key matching with the instruction prompts on X431 IMMO Elite/X431 IMMO Plus key programmer tablet.